Design and construction requirements
Flexible bulk containers shall be sift-proof.
Flexible bulk containers shall be completely closed to prevent the release of contents.
Flexible bulk containers shall be waterproof.
Parts of the flexible bulk container which are in direct contact with dangerous goods:
(a) shall not be affected or significantly weakened by those dangerous goods;
(b) shall not cause a dangerous effect, e.g. catalysing a reaction or reacting with the dangerous
(c) shall not allow permeation of the dangerous goods that could constitute a danger under normal
conditions of carriage.
Service equipment and handling devices
Filling and discharge devices shall be so constructed as to be protected against damage during carriage
and handling. The filling and discharge devices shall be secured against unintended opening.
Slings of the flexible bulk container, if fitted, shall withstand pressure and dynamic forces, which can
appear in normal conditions of handling and carriage.
The handling devices shall be strong enough to withstand repeated use.
Inspection and testing
The design type of each flexible bulk container shall be tested as provided for in 6.11.5 in accordance
with procedures established by the competent authority allowing the allocation of the mark and shall
be approved by this competent authority.
Tests shall also be repeated after each modification of the design type, which alters the
design, material or manner of construction of a flexible bulk container.
Tests shall be carried out on flexible bulk containers prepared as for carriage. Flexible bulk containers
shall be filled to the maximum mass at which they may be used and the contents shall be evenly
distributed. The substances to be carried in the flexible bulk container may be replaced by other
substances except where this would invalidate the results of the test. When another substance is used it
shall have the same physical characteristics (mass, grain size, etc.) as the substance to be carried. It is
permissible to use additives, such as bags of lead shot, to achieve the requisite total mass of the
flexible bulk container so long as they are placed so that the test results are not affected.
Flexible bulk containers shall be manufactured and tested under a quality assurance programme which
satisfies the competent authority, in order to ensure that each manufactured flexible bulk container
meets the requirements of this Chapter.