Provisions for carriage in bulk when the provisions of 7.3.1.1 (b) are applied

In addition to the general provisions of section 7.3.1, the provisions of this section are applicable,
when they are shown under an entry in column (17) of Table A of Chapter 3.2. Sheeted or closed
vehicles or sheeted or closed containers used under this section need not be in conformity with the
requirements of Chapter 6.11. The codes VC1, VC2 and VC3 in column (17) of Table A of Chapter
3.2 have the following meanings:
VC1 Carriage in bulk in sheeted vehicles, sheeted containers or sheeted bulk containers is
permitted;
VC2 Carriage in bulk in closed vehicles, closed containers or closed bulk containers is permitted;
VC3 Carriage in bulk is permitted in specially equipped vehicles or containers in accordance
with standards specified by the competent authority of the country of origin. If the country
of origin is not a Contracting Party to ADR, the conditions laid down shall be recognized
by the competent authority of the first country Contracting Party to ADR reached by the
consignment.

 

When the VC bulk codes are used, the following additional provisions shown in column (17) of Table
A of Chapter 3.2 shall apply:

Goods of Class 4.1

AP1 Vehicles and containers shall have a metal body and where fitted the sheet shall be noncombustible.
AP2 Vehicles and containers shall have adequate ventilation.

Goods of Class 4.2

AP1 Vehicles and containers shall have a metal body and where fitted the sheet shall be noncombustible.

Goods of Class 4.3

 
AP2         Vehicles and containers shall have adequate ventilation.
 
AP3    Sheeted vehicles and sheeted containers shall be used only when the substance is in pieces   
(not in powder, granular, dust or ashes form).
 
AP4   Closed vehicles and closed containers shall be equipped with hermetically closed openings   
used for filling and discharging to prevent the exit of gas and exclude the ingress of moisture.
 
AP5 The cargo doors of the closed  vehicles or closed  containers  shall be  marked  with the  
following in letters not less than 25 mm high:
"WARNING NO VENTILATION
OPEN WITH CAUTION"
This shall be in a language considered appropriate by the consignor.
 

Goods of Class 5.1

AP6 If the vehicle or container is made of wood or other combustible material, an impermeable
surfacing resistant to combustion or a coating of sodium silicate or similar substance shall
be provided. Sheeting shall also be impermeable and non-combustible.
AP7 Carriage in bulk shall only be as a full load.

Goods of Class 6.1

AP7 Carriage in bulk shall only be as a full load.

Goods of Class 8

 
AP7         Carriage in bulk shall only be as a full load.
 
AP8 The design of the  load  compartment of  vehicles or  containers  shall take  account of any 
residual currents and impacts from the batteries.
 
The load compartments of vehicles or containers shall be of steel resistant to the corrosive 
substances contained in the batteries. Less resistant steels may be used when there is a 
sufficiently great wall thickness or a plastics lining/layer resistant to the corrosive substances.
 
NOTE: Steel exhibiting a maximum rate of progressive reduction of 0.1 mm per year under the effects 
of the corrosive substances may be considered as resistant.
The load compartments of vehicles or containers shall not be loaded above the top of their walls.
 
 
Carriage is also permitted in small plastics containers which shall be capable of withstanding, when
fully loaded, a drop from a height of 0.8 m onto a hard surface at
-18 °C, without breakage.
 
 

Goods of Class 9

AP2 Vehicles and containers shall have adequate ventilation.
AP9 Carriage in bulk is permitted for solids (substances or mixtures, such as preparations or
wastes) containing on average not more than 1 000 mg/kg of substance to which this UN
number is assigned. At no point of the load shall the concentration of this substance or these
substances be higher than 10 000 mg/kg.
AP10 Vehicles and containers shall be made leak tight or fitted with a leak tight and puncture
resistant sealed liner or bag, and shall have a means of retaining any free liquid that might
escape during carriage, e.g. absorbent material. Packagings, discarded, empty, uncleaned
with residues of Class 5.1 shall be carried in vehicles and containers which have been so
constructed or adapted that the goods cannot come into contact with wood or any other
combustible material.

7.4

PROVISIONS CONCERNING CARRIAGE IN TANKS

Dangerous goods may not be carried in tanks unless a code is indicated in Columns (10) or (12) of
Table A of Chapter 3.2 or unless a competent authority approval is granted as detailed in 6.7.1.3. The
carriage shall be in accordance with the provisions of Chapters 4.2, 4.3, 4.4 or 4.5 as applicable. The
vehicles, whether they be rigid vehicles, drawing vehicles, trailers or semi-trailers, shall satisfy the
relevant requirements of Chapters 9.1, 9.2 and 9.7 concerning the vehicle to be used, as indicated in
Column (14) of Table A in Chapter 3.2.

The vehicles designated by the codes EX/III, FL or AT in 9.1.1.2 shall be used as follows:
- Where an EX/III vehicle is prescribed, only an EX/III vehicle may be used;
- Where a FL vehicle is prescribed, only an FL vehicle may be used;
- Where an AT vehicle is prescribed, AT and FL vehicles may be used.

7.5

PROVISIONS CONCERNING LOADING, UNLOADING AND HANDLING

General provisions concerning loading, unloading and handling

Previous Matter Next Matter

adrbook.com - Copyright all rights reserved. © 2015-2018